The first rule of DIY: know where your tools are. A purpose-designed 3D-printed toolbox was being launched to the International Space Station (ISS) on European Space Agency (ESA)'s latest ATV resupply spacecraft.
The ESA's fourth Automated Transfer Vehicle cargo craft (ATV-4) lifted off on an Ariane 5 rocket from Kourou, French Guiana at 5:52 p.m. EDT on Wednesday Jun.5, 2013 to begin a 10-day trip to the ISS. The 13-ton ATV-4 delivered more than 7 tons of supplies to the station.
This multitray toolbox is a dreambox of any makers. It was designed to store tools for maintaining Europe's Columbus research module. The toolbox is strong, lightweight and was 3D printed in ULTEM 9085 thermoplastic by Thales Alenia Space in Turin through an ESA contract.
It was then tested by labs in ESA's ESTEC technical centre in Noordwijk, the Netherlands, for 'offgassing' - the release of potentially harmful vapours in the closed environment of the Space Station - to be sure it is safe for use in orbit.
"At the moment, there are five separate bags that tools are stored in, but crewmen have complained that this set-up is cumbersome and time-consuming." explains ESA's project leader, Bram Bekooy.
"The new toolbox includes little clips to hold the tools in place, just like toolboxes you can buy at a hardware store, instead of the previous Velcro inserts that may lose their stickiness over time.
"At the same time, the toolbox exterior still has Velcro covering, so astronauts can leave it in place while they work without it drifting away."
ESA astronaut Frank De Winne advised on the design of the box and its accompanying tools.
"An additional advantage of 3D printing is that if any part of the toolbox breaks we only have to reprint and fly up the tray in question tray rather than the whole box," Bram adds.
"Similarly, making any improvements we might decide on will be only a matter of updating the computer model, then printing the sections."
The tools themselves will fly separately in a soft pouch on ATV-4 because it turned out to be simpler and cheaper to launch them in a bag rather than have to perform complex vibration testing on the toolbox with all its tools inside.
Following this pilot project, future long-duration missions could carry their own 3D printers into space to print out broken parts immediately.
The toolbox plus tools will be evaluated for practical use by ESA astronaut Luca Parmitano, currently aboard the orbital outpost for a six-month stay.
Posted in 3D Printing Applications
Maybe you also like:
- VEEMEE 3D Printer in PlayStation®Home
- Lexus' 3D printed giant puppet finds love in Daniel Kleinman's eye-opening spot
- Daniel Widrig to show off 3D printed design this week in London
- New disk-like invisibility cloak is 3D-printed 'Frisbee'
- The CAD files of first fully 3D printable gun are released
- US Senator Schumer calls for legislation to make 3D printed guns illegal
- 3D printed guitar now available with 76 pickup tones
- Say I Love You with a 3D printed red rose
- Artist Kevin Mack's latest 3D printed sculptures
- The world's first entirely 3D-printed gun is here
- Low-cost DARPA robot hand can pick up 50-pound weights
- Hot Pop Factory launches one-of-a-kind 3D printed wooden jewelry
- 3D printed bionic ear can hear radio frequencies